Napoleon Furnace Installation Course

03  April 2019
Napoleon HVAC Tech Training Events

Napoleon HVAC Tech Training Events

Napoleon Furnace training events in Vermont

Napoleon Furnace Installation Course: Three Dates Offered!

 

Tuesday, April 30 • 8am-4:30pm

Doubletree by Hilton Burlington Vermont
870 Williston Road, South Burlington, VT

Register Online

Wednesday, May 1 • 8am-4:30pm

Vermont Technical College
124 Admin Drive, Randolph Center, VT

Register Online

Thursday, May 2 • 8am-4:30pm

Blodgett Supply
832 Pleasant Street, Newport, VT

Register Online

This training course will cover the major points of installing the Napoleon furnace in a classroom setting following experiential learning methods. The intent of this training is to present to the participant how to follow the installation requirements, as set out in the Napoleon Installation manual, to provide the best possible experience for the end user and contractor alike. Participants will learn from demonstrations, large group discussion, small group discussion, lectures and testing on how to install the Napoleon Furnace.

Topics covered:

  • Type of installation, location and furnace position.
  • Completing electrical wiring, control and power.
  • Gas piping the furnace and accounting for pipe sizing.
  • Ductwork sizing and using existing systems.
  • Condensate piping including good management practices, sizing and materials.
  • Vent & combustion piping including materials used, termination locations, sizing and installation practices.
  • Conversions to propane and testing.
  • Furnace commissioning, including measuring the air flows, gas pressures, vent pressures, Delta Temperatures.

 

< Back to list